Typical Pda Installation; Connect The Hardware; Set U P Dial - Up Networking And Set Up Dun For Your Internet - Zoom 4300 User Manual

Wireless model with bluetooth

Hide thumbs Also See for 4300:

Table of Contents

Typical PDA Installation

The basic steps associated with setting up your Bluetooth

wireless modem and your PDA include the following tasks:

Set up Bluetooth for Dial-up Networking (DUN) and

establish a connection between the PDA and the modem.

Create a dial-up connection to the Internet.

Connect the Hardware

On the back of the modem, make sure the selectable switch is

all the way to the left, the side marked BT (for Bluetooth).

Plug one end of the supplied phone cord into the modem's

Line port, and plug the other end into a telephone wall jack.

Plug one end of the included power adapter into the modem

and the other end into a wall outlet or power strip.

Note: To establish a Bluetooth connection with your PDA and

this modem, your PDA must have built-in Bluetooth

capability or a Bluetooth flash adapter/cradle. You cannot

proceed with these instructions unless the Bluetooth

function is enabled. Tip: If Bluetooth is enabled, you will

see a Bluetooth entry in your Programs folder.

Set Up Dial-up Networking and Establish

Communication

1 1 1 1

Go to Start | Programs | Bluetooth Manager. From the list

of options, tap Dial-up Networking (DUN) and then

Enable DUN. Note: If you cannot bring up Bluetooth

Wireless Modem User's Manual

Table of Contents