Advertisement
4-17
Spool shaft
(0-C30)
Spool shaft(0-C30) is supplied as an assembled parts.
The
me-
chanism inside is shown in Fig. 4-110.
Before and after installing the
Spool shaft, see whether the take up claw turns smoothly throughout
360
revolution by turning it with your finger.
(If Anti-reverse
spring
-E117-
and Transport
3rd gear-C44- are already installed, do not
turn the claw counterclockwise. )
Counter roller (A61)
Install counter roller (A61) in the body with the retainer screw
(A68)and zgear(C93).
When screwing the three set screws(SetT
1. 4x
2. 8), adjust the position of the roller as against the gear,
so that
it
has play about 0, 1~0.2 mm
in the axis direction.
Oiling:
A proper
amount
of L-1 to the both upper and lower bearings.
Fig.4-38
Pig.4-39
C44
*
W14(PB,t=0.1,0.15)
less
: Z
than
(=)
rgd
0.2mm
c20
Transport 3rd gear
(C44)
When
installing Transport
3rd gear (C44), assure
that
the end
portion of Anti-reverse
spring(C117)is placed into the slit of the
gear.
Apply G3 to the shaft and spring.
Spool stopper
(C20)
To stabilize the film transport
control function,
play of the spo-
ol stopper must be minimized.
The play must be within 0.2mm
at
the top,as shown, enabling smooth operation.
Use W14 for the aajust-
ment, if itis needed.
Apply a very small amount of L-1 to the shaft,
but absolutely avoid
oiling the lip.
C16
Pig.4—40
E
Auto re-set actuator plate
( C16)
To ease the assembling operation, the following procedures are
recommended,
Refer to Fig. 4-40.
1
Install Auto re-set actuator plate(C 16), Re-set actuator spring (
C121)and Counter gear mount spring(C122) to the installing
po-
sitions.
At which time, do not engage the spring (C122) with the
Advertisement
