Advertisement
Shutter mechanism
plate
Shutter
system
with the mechanism
plate can be taken apart from
the
mirror
housing as a unit,
But the damper
armA(D132)
must
be disassem-
bled beforehand.
For
the disaasembling,
use a long nose
screw
driver
(225K-E30-A)
through the hole on the other
side of the mirror
housing.
Shock damper
Avoid unneceaasry disassembling of the setting screws(D148).
The
setting screw
on the mirror
actuator
arm
side has a role of mirror
angle
setter.
Mirror
In addition to the retainer plates,
the mirror
is bonded to the sheet
at three points on the reverse
side,
where
the retainer plates are located.
Solvent: Ketone,
Removing of the mirror
sheet
Before
taking out the sheet from the mirror
housing,
shutter
curtain
system,
mirror housing frame (B63) and the relevant parts must be taken
apart beforehand.
Use a proper amount
of solvent;Ketone,
for removing
the mirror housing frame(B63) and light(B95) curtain bonded.
Remove
the two lock
washers (LW13)
and the two arm
rests A,
B
(D126,
D127),
then withdraw the sheet from the back of the mirror hou-
sing,
tilting it as shown
in Fig. 3-2.
Tools
Some
parts require
special tools for disassembling
as in the case
of
assembling.
The tools are explained in Chapter 4,
Advertisement
