Table of Contents
Advertisement
STEP
3
Install exterior assembly
IMPORTANT:
Before installation, make sure the latch is fully
retracted (in the unlocked position)
Unlocked
Route the cables
B
below the latch, and
insert the torque
blade through the
slot in the latch.
Note: Please be sure
the rubber ring is
attached on the
exterior assembly,
which ensure the lock
is waterproof.
10
Locked
Torque
blade
Measure the diameter of
A
the hole in the door.
1-1/2" or 2-1/8"
(38 or 54mm)
Secure the mounting
C
plate with the supplied
screws.
Short Mounting plate
screws are applied to
the door with thickness
of 35mm-45mm. Long
Mounting screws are
applied to the door
with thickness of
45mm-50mm. Do not
overtighten screws.
1-1/2" (38mm)
Remove the spacer
2-1/8" (54mm)
Proceed to next step
Mounting
plate Screws (J)
RF
cable
Cable
Advertisement
Table of Contents
