Table of Contents
Advertisement
Name (number), function
Tank dimensions (P41...P45), for
volume measurement
Specific gravity (P32), for weight
measurement
Threshold offset (P34), interference
sensitivity setting
Gross tank volume (P47)
TDR180003 Rev. I
Adjustable value range
Default value
0...999 999
0
0.01...100
-4095...+4095
0
0...999 999
0
23
www.bindicator.com
Description
Typical dimensions in units of length
for the tank type set in parameter
P40 for volume calculation.
SAP–300: no adjustment available
If the device is set to weight
measurement, the specific gravity of
the material (medium) stored in the
tank must be entered here for weight
calculation. The value to be set is the
ratio (without unit) to the density of
the water.
SAP–300: no adjustment available
Modifies the acceptance threshold
set on the echo chart. It can be
used it to increase (positive value)
or decrease (negative value) the
device's ability to suppress the
interference signal relative to the
default setting. When set to 0,
there is no change from the original
setting.
SAP–300: MAIN MENU / MEAS.
OPTIMIZATION / THRESHOLD
OFFSET
Adjusts the transmitted quantity
by distance. If the value measured
by the device differs from the value
under real conditions, this multiplier
can be used to adjust the result.
The output value is multiplied by
the number set here. The default
multiplier is 1, which does not
change the output.
SAP–300: no adjustment available
Advertisement
Table of Contents
