Bindicator TDR-3000 Installation & Operation Manual page 23

Two-wire guided wave radar
Table of Contents

Advertisement

Name (number), function
Unit system (P00c),
Unit system settings
Distance unit (P00b),
Length unit
Output unit,
volume (P02b)
Volume unit
Output unit,
Weight (P02a)
Weight unit
TDR180003 Rev. I
Adjustable value range
Default value
Selectable values:
− Metric (EU), European unit system
− Imperial (US), US unit system
Metric (EU)
Selectable values
Metric (EU):
− m
− cm
− mm
− custom unit
Imperial (US):
− inch
m
Selectable values
Metric (EU):
− liter
− hl
− m3
− million liters
Imperial (US):
− gallon
− ft3
− barrel
− million gallons
liter
Selectable values
Metric (EU):
− kg
− ton
− US ton
Imperial (US):
− lb
− US ton
− metric ton
kg
19
www.bindicator.com
Description
The units that can actually be used
(length, volume, weight) change
according to the unit system set
according to this parameter. When
setting or changing units, the unit
system must be selected first and
only then can the actual unit to
be used be set (according to the
previously narrowed list).
MAIN MENU / BASIC SETUP /
UNITS / ENGINEERING SYSTEM
The unit of measurement for the
transmitter when the distance and
level are set.
If "custom unit" is selected, the
unit uses the unit of length as the
distance unit based on the value
specified in "User Unit."
MAIN MENU / BASIC SETUP /
UNITS / ENGINEERING UNITS /
DISTANCE UNITS
The unit of the transmitted number
when set to volume measurement.
The device converts the measured
level into volume by calculation.
It is done by using a level-dependent
(non-linear) function.
It also gives the unit of measure for
the "Output" column in the VM table
(OC).
MAIN MENU / BASIC SETUP /
UNITS / ENGINEERING UNITS /
VOLUME UNITS
IT IS ONLY DISPLAYED IF THE PV IS
VOLUME!
The unit of the transmitter number
if the device is set for weight
measurement. The device converts
the measured level into weight.
It is done by using a level-dependent
(non-linear) function.
It also gives the unit of measure for
the "Output" column in the VM table
(OC).
MAIN MENU / BASIC SETUP /
UNITS / ENGINEERING UNITS /
MASS UNITS
IT IS ONLY DISPLAYED IF THE PV
IS WEIGHT!

Advertisement

Table of Contents
loading

Table of Contents