Cleaning The Cabinet - Perlick FR Series Installation & Operation Manual

Glass Frosters Installation & Operation Manual
To manually initiate the automatic defrost cycle
press and hold either the up or down arrows.
The defrost cycle lasts for approximately 20
minutes followed by 2 minutes of drip time
Figure 3c
When the cycle is complete the unit will resume
cooling operation shown on the controller with
remain on the display screen until the next
During normal operation it is recommended that
the doors are not left open to prevent excessive
frost buildup on the coil.
Figure 3d
Cleaning the Condenser
Flammable Refrigerant.
refrigeration tubes.
grille) should be inspected every 30 days,
and cleaned, if necessary. Condenser
should be cleaned using a soft bristled brush
and vacuum. Failure to keep the condenser
clean will cause a loss in condensing unit
Printed in USA
HOW TO OPERATE - GLASS FROSTERS
Cleaning the Doors
the cabinet and inspected for a buildup of
foreign materials, such as syrups, beer, etc.
Buildups on the underside of the doors,
along with the cabinet breaker strips on
which they ride, will cause them to bind,
and therefore, not function as designed. If
dirty, these surfaces should be cleaned with
a mild detergent and water and then coated
material.
To remove doors:
and slide forward until doors clears the
cabinet top. Use the reverse procedure to
reinstall the doors.
Cleaning the Cabinets
water to clean the inside and outside of the
cabinet. Dry thoroughly. Do not allow cleaning
agents or large amounts of water to go down
the drain. Use an acceptable stainless steel
polish to clean all stainless steel surfaces.
Never use steel wool or scouring pads to clean
stainless steel.
Avoiding Stainless Steel Corrosion
Corrosion can be prevented by following product
cautions, cleaning instructions and avoiding use
of certain chemicals or objects which will cause
stainless steel corrosion.
STAINLESS STEEL ENEMY
6