Related Manuals for Perlick DDC Series
Summary of Contents for Perlick DDC Series
- Page 1 Installation & Operation Manual Commercial Back Bar Concessionaire & Direct Draw DDC & DDS Series Model DDC92 Shown Form No. Z2345 Rev. 04.24.2017...
-
Page 2: Table Of Contents
For your own protection, never return Serial Number: _________________________ merchandise for credit without our approval. Purchase Date: _______________________ We thank you for selecting a Perlick product Dealer Name & Address and assure you of our continuing interest in your ______________________________________ satisfaction. -
Page 3: Prior To Installation
(see Electrical Specification discovered, file your claim immediately with the Plate affixed to unit) in accordance with National transport company. Perlick is not responsible for and Local electrical codes. damage in transit. Self-contained Perlick units come equipped with Do not cut cardboard a NEMA 5-15P 90°... -
Page 4: Installation
Concessionaire & Direct Draw Installation & Operation Manual INSTALLATION General Information Installing the Unit If unit has been laid on its • For units equipped with a power cord, the CAUTION cord and plug may be aligned with a recess in back or sides, place unit the back panel to allow the unit to be pushed upright and allow minimum of 24 hours before... -
Page 5: Operation
Concessionaire & Direct Draw Installation & Operation Manual Sealing Cabinet to Floor Cabinet For units without casters or legs, it may be necessary to seal the base of the cabinet to Bead Silicon the floor. This can be accomplished by laying a Sealer (RTV) bead of silicone sealant between the base of the cabinet and the floor (Figure 1). -
Page 6: Maintenance
Concessionaire & Direct Draw Installation & Operation Manual Digital Temperature Control Set the Set Point: To display the Set point value press the when the ‘SET’ label is displayed. The Set point value appears on the display. To change the Set point value, press the keys within 15 seconds. - Page 7 Concessionaire & Direct Draw Installation & Operation Manual chlorides dramatically increases their effect on To clean interior and exterior non-metallic surfaces stainless steel. and removable parts, wash with a mild solution of soap and lukewarm water with a little baking soda. Rinse, rinse, rinse! If chlorinated cleaners are Rinse and dry thoroughly.
-
Page 8: Troubleshooting
Concessionaire & Direct Draw Installation & Operation Manual TROUBLESHOOTING Before Calling For Service If the unit appears to be malfunctioning, read through the Operation section in this manual first. If the problem persists, check through this troubleshooting section. Locate the problem and refer to the cause and remedy before calling for service. - Page 9 Perlick products and offer superior • Write to Perlick Corporation, Customer service life. The use of non-Perlick parts can Service Department, 8300 West Good Hope damage the unit and may void the warranty. Road, Milwaukee, WI 53223.
-
Page 10: Dimensions
Concessionaire & Direct Draw Installation & Operation Manual DIMENSIONS DDC92 WITH DDC68 TEE TOWERS WITH DRAFT ARM 44 [1118] DDC68 13/16" 68" [1727] DDC92 32" 24" [610] DDC92 ONLY 10 3/8" 1 1/8" 14 1/4" 15 7/8" 4 3/4" 18 3/4" [476] BACK LINER TO INSIDE 1"... - Page 11 Concessionaire & Direct Draw Installation & Operation Manual 24" DDS84 WITH TEE TOWERS DDS36 48" WITH DRAFT ARM 1219 DDS108 DDS60 WITH DRAFT ARMS WITH TEE TOWER 20" [508] DDS36 13/16" 44" [1118] DDS60 68" [1727] DDS84 92" [2337] DDS108 10 3/8"...
-
Page 12: Wiring Diagrams
Concessionaire & Direct Draw Installation & Operation Manual WIRING DIAGRAM Printed in USA... - Page 13 Concessionaire & Direct Draw Installation & Operation Manual Printed in USA...
- Page 14 Concessionaire & Direct Draw Installation & Operation Manual Printed in USA...
-
Page 15: Warranty
Any changes to an carrier’s responsibility. Before giving the carrier Order must be in writing and signed by Perlick a clean receipt at time of delivery, make sure you and Buyer. - Page 16 Perlick’s one year labor warranty provides series back bars and accessory parts is 20%. that Perlick will pay for the cost of any labor to The minimum restocking charge for custom replace any defective part for up to one year series cabinets is 50%.
- Page 17 Concessionaire & Direct Draw Installation & Operation Manual 8300 West Good Hope Road • Milwaukee, WI 53223 • Toll Free 800.558.5592 • Fax 414.353.7069 • www.perlick.com Printed in USA...