Refrigeration And Temperature Control; Cleaning The Cabinet; Cleaning Stainless Steel - Perlick CS Series Installation And Operation Instruction Manual

general information

Refrigeration and Temperature Control

the cabinet is equipped with a heavy-duty
refrigeration system designed to automatically
maintain a storage temperature of approximately
38 degrees F.
Adjusting the Temperature
the temperature control is inside the cabinet on
the left-hand side of the evaporator fan panel
assembly. You will need a screwdriver to turn the
adjusting screw. Make small adjustmentsuntil the
desired temperature is achieved.
Colder Temperatures:
■
turn the adjusting screw clockwise (to the right).
Warmer Temperatures:
■
turn the adjusting screw counterclockwise
(to the left).
Temperature Control "Off":
■
turn the adjusting screw completely counter-
clockwise to the "O" position until a click is
noted.
the condenser fan motor turns off and on with
the compressor. the evaporator fan motor is on
all the time.
NOTE:
Cabinet temperatures lower than 34° will not
allow for proper defrosting of the evaporator coil. if
defrosting is necessary, turn the control knob to the
OFF position until coil is defrosted.
Recommended Cleaning Agents
JOb
routine Cleaning
Fingerprints and smears
Stubborn stains and
Discolorations
* Use of propriety names is intended only to indicate a type of cleaner and does not constitute an endorsement.Omission of
any proprietary cleaner does not imply its inadequacy. All products should be used in strict accordance with instructions on
the package.
Form no. Z2281
rev. 04.23.10
CLEANING AGENT*
Soap, ammonia, detergent
areal 20, Lac-O-nu, Lumin Wash,
O'Cedar Cream Polish
allchem Concentrated Cleaner,
Samae, twinkle, Zud restoro,
grade F or FFF italian Pumice,
Whiting or talc, Liquid nu Steel,
Copper's or revere Stainless Steel
Cleaner, Lumin Cleaner, Sta-Clean,
Cameo Copper Cleaner, allen Polish
highlite, Penny-brite, Copper brite
nOte: Do not Use Steel Wool or Scouring Pads to clean stainless steel.
Perlick is committed to continuous improvement. therefore, we reserve the right to change specifications without prior notice.

Cleaning the Cabinet

Use a mild detergent and water to clean the inside
and outside of the cabinet. Dry thoroughly. never
use a scouring pad or abrasive cleanser.
NOTE: an industrial strength, commercial cleaner
can be used to clean the outside of painted
cabinets.
Cleaning the Condenser
Use a long handled, stiff brush to clean the dirt
from the front surface of the condenser. Keeping
the condenser free from dust and dirt will ensure
efficient operation.
CAUTION: Do not bend the fins while brushing the
front of the condenser.
Condenser
the condenser (located behind the front grille
cover) should be inspected every 30 days and
cleaned, if necessary.
Failure to keep the condenser clean will cause a
loss in condensing unit efficiency.
apply with sponge or cloth.
Can be used on all finishes.
Provides barrier film to minimize
fingerprints. Can be used on all finishes.
rub lightly, using dry or damp
cloth in the direction of polish
lines on the stainless steel.
4
COMMENTS