Table of Contents
Advertisement
4. With a T30 bit torque driver set to a force of 8.0 in-lbf (0.904 N-m), gradually tighten all
PEEK nuts in the sequence of A, B, C, and D with even pressure.
Important: Do not use a force greater than 8.0 in-lbf (0.904 N-m). Exceeding this force
may over-torque the screw, causing damage to the processor, heatsink, and screw.
5. Examine all corners of the heatsink to ensure that the PHM is firmly attached to the
CPU socket.
8.0
in-lbf
0.904
3 4
5 6 7 8 9 1 0 1 1
N-m
1U Heatsink
8.0
in-lbf
0.904
3 4
5 6 7 8 9 1 0 1 1
N-m
2U Heatsink
8.0
in-lbf
0.904
3 4
5 6 7 8 9 1 0 1 1
N-m
4U Heatsink
47
Chapter 2: Installation
Advertisement
Table of Contents
