Paradyne 3825Plus User Manual page 32

COMSPHERE 3825Plus Modem
Q n Result Codes
Result codes are informational messages (such as Connect and Ring) sent from the modem and displayed on the
asynchronous DTE terminal. Refer to Table A-1 for a list of result codes.
Q, Q0 Enables modem to send result codes to the DTE.
Q1 Disables modem from sending result codes to the DTE.
Q2 Enables in Originate mode only for modem to send result codes to the DTE. Required for most
UNIX applications.
S n = r
Change S-Register
Changes the contents of an S-register, where n is the S-register, and r is the new value.
S n ? Display S-Register
Displays the value of an S-register, where n is the S-register number.
T Tone Dial
Sets the modem for Tone (DTMF) dial mode. See D command.
V n
Result Codes Format
Controls whether or not result codes appear as words or as numeric codes. Some DTEs do not recognize result codes as
words; therefore, numbers are required. The Numbers (2) format is required for some modem pooling applications. Refer
to Table A-1 for a list of result codes.
V, V0 Displays result codes in Number (1) format (digits).
V1 Displays result codes as text.
V2 Displays result codes in Number (2) format (digits).
X n Extended Result Code, Dial Tone Detect, and Busy Tone Detect
The X n command sets three configuration options simultaneously:
Extended
Result Code
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42,MNP
X7 Use DTE Rate
EXTENDED RESULT CODE
Informational messages such as VF (line) connect rate and Error Control are displayed with the result codes.
Disable. Displays basic result codes: OK, CONNECT, RING, NO CARRIER, and ERROR.
Enable. Displays basic result codes in addition to the CONNECT rate message (for example, CONNECT 14400).
4-6
Table 4-1
(4 of 14)
3825 Plus AT Commands
Dial Tone Busy Tone
Detect Detect
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable
January 1999 3825-A2-GB30-40