Table of Contents
Advertisement
Smoke Control Damper
14.5. Dampers must be stored in covered buildings, in an
environment free of aggressive vapours, gases and dust.
A temperature in the range of -5°C to +40°C and relative
humidity max. 80% must be observed in the buildings.
When handling during storage, the dampers must be pro-
tected against mechanical damage.
14.6. The scope of delivery includes a complete damper and
delivery note.
15. Warranty
15.1. The manufacturer provides a 24-month warranty on
dampers from the shipment date.
The manufacturer's warranty for SDJR-M dampers
completely expires after any unprofessional handling by
untrained workers (see chapter 16.1.) With the control
device, disassembly of electrical elements, i.e. actuators,
communication and power supply devices.
The warranty also expires when dampers are used for pur-
poses, equipment and working conditions other than those
permitted by these technical conditions or after mechani-
cal damage during handling.
15.2. If the dampers are damaged by transport, it's neces-
sary to draft a report with the courier upon acceptance for
the possibility of a later complaint.
Lindab reserves the right to make changes without prior notice
Rev: 2023-10-23
Last modified: 2021-03-26
l i n d ab | for a b ette r cli m ate
Installation, operation, maintenance
and operational check
16. Assembly
16.1. Damper installation, maintenance and serviceability
checks may only be performed by personnel qualified for
these activities, i.e. "AUTHORISED PERSONNEL".
Its extension is provided by a trained person directly from
the trainer.
Upon the "CERTIFICATE'S" expiry, it loses its validity and is
excluded from the trainer's registration.
Only professionals taking over the warranty for the work per-
formed may be trained.
16.2. Dampers must be installed in compliance with all appli-
cable safety standards and regulations.
16.3. For the damper's reliable function, care must be taken
to ensure that the closing mechanism and the bearing sur-
faces of the blade are not clogged with dust deposits, fibrous
or sticky substances and solvents.
16.4. Actuator control without voltage.
Using a special key (supplied with the actuator), the damper
blades can be manually adjusted to any position. In a simple
way, the damper's function can be tested.
SDJR-M
57
Advertisement
Table of Contents
