LawnMaster CLM2432K Instruction Manual page 30

TROUBLESHOOTING
Poor cutting or motor
labours.
Area of cut (battery
duration) is not large
enough.
The cutting blade is not
rotating while the mower
is switched on.
noise.
No charging procedure
possible.
The charge control LEDs
do not light up after
inserting the mains plug
Possible clogging.
Height of cut is too low.
The grass is too high.
The grass is wet or damp.
The grass is dense.
The cutting blade is obstructed. obstruction (always wear gardening
Cutting blade is damaged.
The battery contacts are
contaminated.
or battery charger are defective.
The battery has a fault.
Mains plug of the battery
charger is not plugged in
(properly).
battery charger are defective.
30
clear out as necessary (always wear
gardening gloves).
slower.
slower.
slower.
slower and cut more frequently.
gloves).
Replace the blade.
Clean the battery contacts (e.g. by
inserting and removing the battery
several times) or replace the battery.
Replace the battery.
outlet.