Installing The I/O Card - Paradyne 9261 Installation Instructions Manual

Installing the I/O Card

The NAM's I/O card provides the COM port, network, and
DTE connections. The I/O card inserts directly behind the NAM
that it supports. Slot numbers are identical (in this case, Slot 01)
to facilitate correct installation.
1. Remove the I/O card from the shipping box. Handle only
by the top and bottom edges to avoid damaging the card.
2. At the rear of the housing, align the I/O card with the
upper and lower tracks of the slot. Push gently towards
the midplane until it stops and you cannot push the card
any further.
5-Slot
Screws
3. There are two captive screws on the I/O card. Using a
screwdriver, alternately tighten each screw until the
screws are all the way in.
2-Slot
Rear View
4
Screws
496-15155
NAM
Rear Panel
9 2
6 1
N E
T
1
NET 1
D B
M
DBM
(For
Future
N E
Use)
T
2
NET 2
P O
R T
1
Port 1
P O
R T
2
Port 2
COM
C O
M
97-15637