Quick Reference; Quick Start Procedure - Paradyne ACCULINK 3150 Quick Reference

Zhone 3150 csu: reference guide

Hide thumbs Also See for ACCULINK 3150:

ACCULINK 3150 CSU

Quick Reference

Document Number 3150-A2-GL11-60

February 1998

The following procedure is offered for experienced CSU users who are familiar with the

3150 CSU installation process and have no special requirements for their application.

Refer to the ACCULINK 315x Channel Service Unit Operator's Guide (Document No.

3150-A2-GB21) for more information.

1. Attach the power cord to the rear of the CSU and the other end to a grounded

115 Vac power outlet.

2. Attach the DTE cable (DB15) and the 8-pin network cable to the DTE and

NETWORK connectors, respectively, located on the CSU rear panel. Then,

connect the other end of the DTE cable to the CPE. Connect the other end of the

network cable to the RJ48C jack provided by the telephone company. See

Appendix D, Pin Assignments , in the Operator's Guide for more information.

3. Power on the CSU to perform the power-up self-test. See the Power-Up Self-Test

section in Chapter 2 of the Operator's Guide for more information.

4. If you intend to use front panel emulation, connect the cable from the PC to the

COM port on the rear panel of the CSU.

NOTE:

To configure the CSU remotely, refer to the Acquiring/Releasing the User

Interface section in Chapter 3, Operation, in the Operator's Guide .

5. If you intend to manage the 3150 CSU with SNMP, cable either the COM or

MODEM port (as appropriate for your configuration). Then, configure the SNMP

management link. See Chapter 3, Operation, and Appendix C, Configuration

Options, in the Operator's Guide for more information.

6. The Factory 1 configuration for ESF framing format and B8ZS line coding format is

the default configuration and is appropriate for most networks. If this configuration

does not work for you, try the Factory2 configuration for D4 framing format and AMI

line coding format. To further customize configuration options, refer to Changing

Configuration Options in Chapter 3, Operation , and to Appendix C, Configuration

Options, in the Operator's Guide .

7. During the power-up self-test, the FAIL LED flashes, then all LEDs blink twice.

When the test is complete, verify that the CSU is functional by observing that the

OK, NETWORK SIG, and DTE SIG LEDs are lit.