Necessary Settings Before Use; Charging The Battery Pack - JVC GZ-MG335 U Instructions Manual

Necessary Settings before Use
16
Be sure to configure the following three
settings before use.
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
3
Connect the AC adapter.
DC Jack
• You can also connect the AC adapter using
the Everio dock connector.* (0 pg. 10)
*
GZ-MG330 model does not include the
Everio dock.
• The charge lamp blinks to indicate charging
has started.
• When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
• To detach the battery pack
Slide and hold
BATT. (0
step 2), then
remove the battery pack.
• To check the remaining battery power
See page 18.
IEDD
• You can also use the camera with just the
AC adapter.
• Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.