Troubleshooting - JVC GZ-MG335 U Instructions Manual

Troubleshooting
The camera is a microcomputer-controlled
device. External noise and interference (from
a TV, a radio, etc.) might prevent it from
functioning properly.
The following phenomena are not
malfunctions.
• The camera heats up when it is used for a
long time.
• The battery heats up during charging.
• When playing back a video file, the
image stops momentarily or the sound is
interrupted at junctions between scenes.
• To solve the problem, first follow the
instructions below.
• If the problem is not solved, reset the
camera. (0' below)
• If
the problem persists, please consult your
nearest JVC dealer.
• To reset the camera
1) Close the LCD monitor to turn off the
camera and remove the power supply
(battery pack or AC adapter) from the
camera, then reattach
it.
2) Select [FACTORY PRESET] from the
MENU. (0' pg. 65)
18
• Charging may stop in places subject to extremely high/low
temperatures to protect the battery. It is recommended
to charge it in places with a temperature of 10°C to 35°C
(50°F to 95°F).
• When the battery is already fully charged, the lamp does
not light. Check the remaining battery power.
• Make sure to use the camera under appropriate operating 72
temperatures.
• The battery is worn out and needs to be replaced. Please
purchase a new one.
• Fully charge the battery, and then run it down. If the 16
problem persists, the battery is worn out and needs to be
replaced. Please purchase a new one.
• Move to a place where not affected by vibration or
excessive sound.
• The drop detection function operated. Close the LCD 64
monitor and open it again. To turn off this function, set
[DROP DETECTION] to [OFF].
• Connect the AC adapter securely.
• Detach the battery pack once again and reattach it firmly.
• Replace the dead battery with a fully charged one.
The
ac~esSJcharg
lamp
onlhe
camera
,does not
light
during'
charging.
• If the camera is not operated for 5 minutes while the power
is on, it turns itself off automatically to conserve power. To
turn the camera on again when using the battery pack,
close the LCD monitor and open it again. When using the
AC adapter, perform any operation such as zooming.
, • Adjust the brightness of the LCD monitor. 64
67