Lincoln Electric 11141 Service Manual page 125

F-79
CURRENT TRANSDUCER REMOVAL AND REPLACEMENT (continued)
21. Replace the current transducer.
22. Replace the two 3/8" mounting nuts previously
removed.
23. Reconnect plug #J90 to the current transducer.
24. Replace any necessary cable ties previously cut.
25. From the rear of the machine, replace the heavy
flex lead to the bottom of the output diode heatsink
assembly using a 1/2" wrench. Note: Don't forget
to include all washers.
26. Replace the output diode heatsink assembly pre-
viously removed using a 3/8" wrench.
Note: Be sure to place insulation in its original
location.
27. Replace leads X2, #20, X4, #40 previously
removed from the two output diode modules.
Torque to 30-40 inch lbs.
28. Perform the Snubber Board Replacement
Procedure.
TROUBLESHOOTING AND REPAIR
POWER WAVE
29. The rear of the machine may now be placed back
into its original position.
30. Using a 3/8" wrench, replace leads #202, #203,
#206, and #207A previously removed from the
reconnect switches.
31. Tighten the metal nut previously removed from the
inside of the rear wall on the back of the machine.
Channel locks may be necessary.
32. Replace the large plastic nut from around input
power line located at the back of the machine.
33. Replace the four leads to the reconnect panel in
their proper locations.
34. Replace the two CB2 circuit breaker leads previ-
ously removed.
35. Using a 5/16" nut driver, replace the four screws
from the rear assembly.
36. Replace the case wraparound cover.
® 355M/405M
F-79