Table of Contents
Advertisement
F-54
MAIN SWITCH BOARD REMOVAL & REPLACEMENT (continued)
FIGURE F.22 – MAIN SWITCH BOARD LEAD LOCATIONS
207
J21
PROCEDURE
1. Remove the input power to the POWER
WAVE
355M/405M.
®
2. Using a 5/16" nut driver remove the case wrap-
around cover.
3. Perform the Input Filter Capacitor Discharge
Procedure detailed earlier in this section.
CAUTION
Observe static precautions detailed in PC Board
Troubleshooting Procedures at the beginning of
this section. Failure to do so can result in perma-
nent damage to equipment.
4. Locate the main switch board and all associat-
ed plug and lead connections. See figure F.22.
See Wiring Diagram.
TROUBLESHOOTING AND REPAIR
-
-
+
+
201
208
-
-
+
+
203
2
POWER WAVE
202
-
-
+
+
204
205
-
-
+
+
206
5. Using a 3/8" nut driver, remove the input lead
shield from the area at the bottom of the main
switch board.
6. Using a 7/16" socket, remove leads 201, 202,
203, 204, 205, 206, 207, 208, 209 from the
switch board. Note lead terminal locations and
washer positions upon removal.
7. Locate and disconnect the three harness plugs
associated with the main switch board. Plugs
#J20, #J21, #J22. See Figure F.22.
8. Locate the eight capacitor terminals and
remove the nuts using a 7/16" socket or nut dri-
ver. Note the position of the washers behind
each nut for replacement.
®
355M/405M
F-54
J22
209
J20
Advertisement
Chapters
Table of Contents
