Table of Contents
Advertisement
F-55
MAIN SWITCH BOARD REMOVAL & REPLACEMENT (continued)
9. Using a 3/16" allen wrench remove four allen
bolts and washers as shown in Figure F.23.
At this point, the board is ready for removal.
10. Carefully maneuver the board out of the
machine.
11. Apply a thin coat of Penetrox A-13 to the
IGBT heatsinks on the back of the new switch
boards mating surfaces. Note: Keep com-
pound away from the mounting holes.
12. Replace the four allen bolts and washers pre-
viously removed.
13. Replace the eight capacitor terminal nuts,
washers, and necessary leads previously
removed.
14. Reconnect the three harness plugs previous-
ly removed.
TROUBLESHOOTING AND REPAIR
FIGURE F.23 – 3/16" ALLEN BOLT LOCATION
-
-
+
+
3/16" ALLEN BOLTS
-
-
+
+
POWER WAVE
-
-
+
+
-
-
+
+
15. Reconnect the nine leads (#201-#209) that
were previously removed.
16. Replace any necessary cable ties previously
removed.
17. Pre-torque all screws to 25 inch lbs. before
tightening to 44 inch lbs.
18. Replace the input lead shield previously
removed.
19. Replace the case wraparound cover.
NOTE: Any instructions that are packaged with
the replacement board will supercede
these instructions.
®
355M/405M
F-55
Advertisement
Chapters
Table of Contents
