Before Calling Service Personnel - Zenith DA3520 Operating Manual

PAGE 46 REFERENCE
Before Calling Service Personnel (Cont'd)
Symptom
Recording cannot be • The components are connected
done.
• The source is selected incorrectly.
• The antennas are connected poorly.
Radio stations cannot
be tuned in.
• The signal strength of the stations is too
• No stations have been preset or preset
The remote control • The remote control is not pointed at the
does not work properly.
• The remote control is too far from the
• There is an obstacle in the path of the
• The batteries in the remote control are
Using the RESET button (located on the bottom of DVD receiver)
This button is used to solve the problem as following symptom;
• When the power cannot be turned on, even if the power cord is connected to the outlet.
• When the window display does not display.
• When the DVD receiver does not operate normally.
- Use a pencil or ball-pen when you press the RESET button.
NOTES:
• If the RESET button is pressed, then all memorized data will be cleared such as preset stations etc..
• Reset the settings according to instructions.
You can reset the DVD receiver also as below.
Unplug the power cord and then plug the power cord again after more than five seconds.
Symptoms and Correction
Cause
incorrectly.
weak (when tuning in with automatic
tuning).
stations have been cleared (when
tuning by scanning preset stations).
remote sensor of the DVD receiver.
DVD receiver.
remote control and the DVD receiver.
exhausted.
Correction
• Connect the components correctly.
• Select the source with FUNCTION but-
ton (CD/DVD, VIDEO 1, VIDEO 2 or
Tuner).
• Connect the antenna securely.
• Adjust the antennas and connect an
external antenna if necessary.
• Tune in the station manually.
• Preset the stations (page 31).
• Point the remote control at the remote
sensor of the DVD receiver.
• Operate the remote control within about
23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.
RESET Button
(DVD receiver's bottom)