Commissioning - Gree GC202306-I Service Manual

Gree
(3) Install in The Unit
The wired controller can be directly installed in the unit by installation personnel.
(4) Removal
Caution!
For removing wired controller in figure ①, please use slot type screwdriver for easily lever the panel
and soleplate of wired controller. If the rear cover of wired controller is required to remove, please
unscrew the screws of wiring terminals first.

7.Commissioning

Safety measures must be taken for outdoor operation. All commissioning personnel and maintenance personnel must

master the building construction safety specifications and strictly follow the specifications.
Refrigerators, electricians, welders and other special types of workers must hold special work permits, and it is

prohibited to work in different types of work. When operating the equipment, the power supply of the whole unit must
be cut off, and the operation must be carried out in strict accordance with the equipment safety requirements.
All installation and maintenance operations must comply with the design requirements of this product and the safety

specifications of the country or region where it is located. Illegal operations are strictly prohibited.
7.1 Inspection before Commissioning
After the heat pump unit, wire controller, water system and electrical wiring have been installed, be
sure to check the unit according to the following table.
Fig. 6-5 Installation of Wired Controller
Fig. 6-6 Removal of Wired Controller
WARNING!
29
SWIMMING POOL HEAT PUMP (R32)