Electrolux KEAF2100L User Manual page 22

Problem and alarm code
Technical malfunction of the appliance.
• The indicator flashes 12 times intermit‐
tently.
• Acoustic signal sounds 12 times intermittent‐
ly.
The level of water inside the appliance is too
high.
• The indicator flashes 15 times intermit‐
tently.
• Acoustic signal sounds 15 times intermittent‐
ly.
The appliance stops and starts more times dur‐
ing operation.
The programme lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
The appliance door opens during the wash cy‐
cle.
Rattling/knocking sounds from inside the appli‐
ance.
The appliance trips the circuit-beaker.
Refer to "Before first use", "Daily use",
or "Hints and tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
22 ENGLISH
Possible cause and solution
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instructions.
• It is normal. It provides optimal cleaning results and energy
savings.
• If the delayed start option is set, cancel the delay setting or
wait for the end of the countdown.
• Refer to the consumption values table in the chapter "Pro‐
grammes".
• The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The AirDry function is activated. You can deactivate the
function. Refer to "Settings".
• The tableware is not properly arranged in the baskets. Re‐
fer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and the
capacity of the meter or turn off one of the appliances in
use.
• Internal electrical fault of the appliance. Contact an Author‐
ised Service Centre.
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.