Table of Contents
Advertisement
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the lid locks
into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
Do not fill the compartment (A) with more
than 30 ml of gel detergent.
9.2 Setting and starting a
programme
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode.
3. Press the programme button repeatedly
until the indicator of the programme you
want to select starts flashing.
4. Close the appliance door to start the
programme.
Starting a programme with delay start
1. Set a programme.
2. Press the delay button to delay the start
of the programme by 3 hours.
The indicator
is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to
change the programme.
When the countdown is complete, the
programme starts.
Opening the door while the appliance
operates
Opening the door while a programme is
running stops the appliance. It may affect the
energy consumption and the programme
duration. After closing the door, the appliance
continues from the point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it as this may cause
damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running programme
ends.
Cancelling the delay start
Press the on/off button for 3 seconds until the
appliance is in programme selection mode.
When you cancel the delay start, you have to
set the programme again.
Cancelling the programme
Press the on/off button for 3 seconds until the
appliance is in programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a new
programme.
The Auto Off function
This function decreases energy consumption
by deactivating automatically the appliance
when it is not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not
started.
ENGLISH
15
Advertisement
Table of Contents
