Foot Switch Mode; System Dump; Dump Current; Dump All - Kawai MP8 Owner's Manual

8.2.12 Foot. Switch Mode
8.3 System Dump
8.3.1 Dump Current
Dump
Pres:
Dung
Current
s VALUE UP
Current
Sure?
8.3.2 Dump All
leted! |
This parameter sets the mode of FootSW's function.
Normal: The type of controller assigned to the footswitch is a common Setup
parameter "FootS W CC#". (See P.39)
Setup+: The footswitch is pushed 1 time, and Setup number will be increased
by 1.
Note: .
When the value is "Setup+",FootSW CC# page won't be displayed.
This function transmits the current and active settings of the MP3 as a System
Exclusive Message via the MIDI OUT
Press the SYSTEM button. Then press the MENU-UP button until "Dump
Current" appears on the display.
Press the VALUE-UP button. The display will ask for confirmation.
To cancel Dump Current at this point, press the VALUE-DOWN button.
Otherwise, press the VALUE-UP button again.
The display will change to read "Completed!!". Dump Current is complete.
Note:
Loading the data back to the MP8 will change the current settings.
SETUP and SYSTEM data will not change. You can use this function to
temporarily change the setting from your sequencer Hf you want to
save the setting, you must use the STORE procedure and save as Setup,
This function transmits all the Setups of the MP8 as System Exclusive
Messages via the MIDI OUT. Lise this function to ba
external MIDI seguencer
Press the SYSTEM button. Then press the MENU-UP button until "Dump
All" appears on the display.
Press the VALUE-UP button. The display will ask for confirmation.
To cancel Dump All at this point, press the VALUE-DOWN button.
Otherwise, press the VALUE-UP button again.
When the data is done transmitting, the display will change to read
"Completed!!". Dump All is complete.
Note:
45