Kawai MP8 Owner's Manual page 13

Press one of the A-D buttons in the second row. If you press B, a variation
sound "60's EP2" is recalled.
Select the variations with the sound select buttons in the second and third
TOWS.
"STRINGS/ BRASS/ © PAD/
PIANO E.PIANO DRAWBAR ORGAN STRINGS/ BRAGS:
JASS/
SA GUITAR
CI CI fom Pm 30903
CIC 16 TOI IO 20 13
The display shows the currently selected sound name.
Note:
Internal sounds or Setups can be also selected using the/ALUE buttons.
You should also listen to the preprogrammed Setups.
Setups are organized in 8 Banks with 32 Numbers each (total 256 Setups).
Press the SETUP button to change to SETUP mode and select a Setup by
pressing one of the Bank buttons in the upper row followed by a Number
button in the second and third row.
The display shows the currently selected Setup name.
In Sound mode, the "1" in the display indicates that the zone | is currently
selected.
When the multitimbre is off, the default settings ofthe zones are as follows.
It is recomended for simple MIDI transmit/receive use on stage etc.
ZONE ON/OFF
CI CI CI LO
l 2 3 4 Zone i Both
Zone2 Both
Zone3 Both
Zone4 Both
LI Zone 1 Internal
C9
2 Zone 2 Internal
| Zone3 External On (Plays external device) The default TX channel is 1,
D : Zone 4 External Off (Muted)
On (Plays internal sound)
Off (Muted)
When the multitimbre is on, the default settings of the zones are as follows.
It is recomended for recording/playback with PC or sequencer
On (Plays internal sound & external device)
The default TX channel is |
Off (Muted)
Off (Muted)
Off (Muted)
The zone mode for each zone is indicated by the INT/EXT LED beside the
faders. The zone status for each zone is indicated by the ZONE ON/OFF
buttons. If the ZONE buttons is red, this zone is assigned to the entire
keyrange of the MP8. If the button is green, the key range for that zone is
less than the entire key range. You can check the key range setting by holding
the SELECT button for the zone for 1 second.