Bender Range; Solo; Solo Made; Common Parameters: Raise - Kawai MP8 Owner's Manual

-6.2.28 Bender Range
"vt Grand
6.2.29 Solo
fire ne azzo he dz gent
B LORDE gari
i
molo = Om
Int: This sets the Bender Range in semitone steps. The value changes
from 0 to 7.
Ext: This is used to transmit Bender Range information to external sound
modules. If the Tx Bender Range is "On", the value is transmitted
when a SETUP is recalled. The value changes from 0 to 12.
When the Bender is "Off", this page won't be displayed.
This parameter turns the Solo Mode On/Off.
When Solo is turned "On" only one note will be heard for the selected zone
even if more than one note is being played simultaneously This can be used
to effectively simulate the performance characteristics of a monophonic
synthesizer or as a special performance tool for playing solo parts. Solo
mode can also be used while playing a polyphonic part from another zone.
6.2.30 Solo Mode
i Grand
=Last
This parameter determines which note will be played when Solo is ON and
more than one note is being played simultaneously There are three choices
for Solo note priority.
Last: The most recently played note within a group of notes wil! be heard
when Solo is ON
Hi: The highest note played within a group of notes will be heard when
Solo is ON.
Low: The lowest note played within a group of notes will be heard when
Solo is ON.
When the Solo is "Off", this page won't be displayed.
6.3 Common Parameters
Common parameters are affecting all zones.
6.3.1 Stretch Tuning
The hearing ability of a human is uneven and is not accurate with high
frequency and low frequency as it is with the middle range. The tuning of
an acoustic piano is stretched to compensate for this so the sound will be
heard naturally to the ears.
Off: The tuning is flat without stretching:
On: The tuning is always stretched.
Piano: The tuning is stretched only when piano sounds are selected.
On W: Same as "On" but the stretching is wider
Piano W: Same as "Piano" but the stretching is wider