Table of Contents
Advertisement
Available languages
Available languages
4.16 Cancelling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme. Previous
programme will be cancelled. End / Cancel light will
flash continuously to notify that the programme has
been canceled.
Pump function is activated for 1-2 minutes regardless
of the programme step, and whether there is water
in the machine or not. After this period, your machine
will be ready to start with the first step of the new
programme.
C
Depending on the step where the programme was
canceled in, you may have to put detergent and
softener again for the programme you have selected
anew.
4.17 End of programme
"End" appears on the display at the end of the
programme.
1. Wait until the loading door light illuminates steadily.
2. Press On / Off button to switch off the machine.
3. Take out your laundry and close the loading door.
Your machine is ready for the next washing cycle.
4.18 Your machine is equipped with a
"Standby Mode"
In case of not starting any programme or waiting
without making any other operation when the
machine is turned on by On/Off button and while it is
in selection step or if no other operation is performed
approximately 2 minutes after the programme
you selected has come to an end, your machine
will automatically switch to energy saving mode.
Brightness of indicator lights will decrease. Also, if
your product is equipped with a display showing the
programme duration, this display will completely turn
off. In case of rotating the Programme Selection knob
or pressing any button, lights and display will restore
to their previous condition. Your selections made while
exiting the energy saving mode may change. Check the
appropriateness of your selections before starting the
programme. Readjust if necessary. This is not a fault.
18 / EN
5 Maintenance and cleaning
Service life of the product extends and frequently
faced problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to
prevent accumulation of powder detergent in time.
Lift the rear part of the siphon to remove it as
illustrated.
C
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, clean the siphon.
2 Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning.
3 After cleaning, replace the siphon back to its seating
and push its front section downwards to make sure
that the locking tab engages.
5.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please
see Operating the product - Programmes.
For products without drum cleaning, follow the below
steps to clean the drum:
Select Additional Water or Extra Rinse auxiliary
functions. Use a Cottons programme without
pre-wash. Set the temperature to the level
recommended on the drum cleaning agent which
can be provided from authorized services. Apply
this procedure without any laundry in the product.
Before starting the programme, put 1 pouch of special
drum cleaning agent (if the special agent could not be
supplied, put max. 100 g of powder anti-limescale) into
the main wash detergent compartment (compartment
no. "2"). If the anti-limescale is in tablet form, put only
one tablet into the main wash compartment no. "2".
Dry the inside of the bellow with a clean piece of cloth
after the programme has come to an end.
C
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing
machines.
Washing Machine / User's Manual
Advertisement
Table of Contents
