Safety Instructions - Parkside ZKGS 2100 UG Operation And Safety Notes

Anleitung_4300696:_ 10.07.2009
GB/IE/
CY
speed steel (HSS Steel) may not be used.
2. Safety instructions for the Laser
Important:
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment by
taking suitable precautions for the prevention
of accidents.
Do not look directly into the laser beam
without wearing eye protection.
Never look directly into the path of the laser
beam
Do not direct the laser beam at reflective
surfaces, people or animals. Even a weak
laser beam can cause damage to the eyes.
Caution - if alternative instructions to the
above mentioned are followed, this could
lead to dangerous exposure to radiation.
Never open the laser module.
IWhen the laser is not going to be used for
an extended period of time, the batteries
should be removed.
Never use an optical instrument (e.g.
magnifying glass) to view the laser beam.
Check the laser for damage regularly, and
before each use. To avoid danger, do not
use the equipment if it shows signs of
damage.
A damaged laser should only be repaired at
a customer services workshop.
3. Safety instructions for the batteries
Never recharge the batteries. This could
cause an explosion.
Keep batteries out of the reach of children,
do not dispose of them in fire, and do not
short circuit or disassemble them.
Clean battery and equipment contacts
before inserting the battery for use.
12
12:31 Uhr Seite 12
Empty batteries must be taken out of the
machine immediately. There is a risk of
leakage!
Always replace all batteries at the same
time. Only replace with new batteries of the
same type.
Contact with skin, eyes and mucous
membranes should be avoided. Should
these places come into contact with battery
acid, wash immediately with clear water
and seek the advice of a doctor if
necessary.
Do not store batteries in extreme
conditions, e.g. on radiators or in direct
sunlight. High risk of leakage
4. Maintenance and service
The following conditions can have an
influence on noise impact on the operator:
- Type of sawblade (e.g. saw blades
designed to reduce noise development)
- Material of the workpiece
- The force with which the workpiece is
pushed against the sawblade
Faults on the machine or its guards, safety
devices and blade must be reported to the
person in charge as soon as they are
discovered.
5. Safe operation
Use a saw blade which is appropriate for
cutting the material.
Never use the drag, crosscut and mitre saw
for cutting any materials other than those
provided by the manufacturer.
When transporting the equipment, use the
transportation devices - never the safety
devices - for handling or transportation.
Only use the saw if it is in good condition
and properly maintained.
Take care that the device for swivelling the
arm for mitre-sawing is securely fastened.
The floor around the machine must be
even, clean and free from loose particles
such as woodchips and cuttings.
The serviceperson must be sufficiently
skilled at using, adjusting and operating the
machine.
Only use sufficiently sharp saw blades. The
top speed stated on the saw blade is to be