HARDWARE PREPARATION AND INSTALLATION
Depending on your application, it may be necessary to cut the W2
wiring trace short (cut-trace short). Be careful not to cut adjacent
PCB traces, nor cut too deep into the multi-layer circuit board.
If the cut-trace short on a jumper header is already cut, you can
return the MPB to its default setting by installing a user-supplied
fabricated jumper.
Figure 2-1. M68MPB916R1 (C version) Parts Location Diagram (top view)
2-2
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
CAUTION
M68MPB16R1UM/D