Advertisement
Page 23 of 36
7c – CHECKS AND MAINTENANCE OPERATIONS TO BE CARRIED OUT
1) AIR FILTER CLEANING
The air filter cleaning is essential for these machines, and it is
operation which must be carried out before each
The filter must be REPLACED with a new one every 250 hours. The procedure for cleaning the filter
Briggs & Stratton
suggested by
detailed information.
Air filter for B&S Vanguard Series 49 and LONCIN LC2P77F engines
Figure 15 and 16
1. Unhook the locking devices (A, figure 15) and remove the lid (B).
2. Remove the air filter (C, figure 15).
3. To remove the debris, gently tap the filter on a hard surface. If the filter is too dirty, replace it with a
new one. DO NOT BLOW WITH COMPRESSED AIR! DO NOT USE SOLVENTS!
3) Extract the dipstick and check the oil level. The
correct level corresponds to the upper mark indicated
on the dipstick (B, see figure 6).
4) If the oil level is low, fill up slowly through the
filling hole C in figure 6. Do not add too much oil.
After having added the oil, wait for one minute before
checking the level once again.
5) Reinstall and tighten the level dipstick A.
BEFORE EACH USE
use.
is described below. Read the engine manual anyway, so to have more
an
35451480EN ‐ FOX 110‐4WD and FOX 95‐4WD User and Maintenance Manual
Advertisement
