Advertisement
Page 23 of 35
3) Extract the dipstick and check the oil level. The correct level must be between the signs indicated
(maximum/minimum) on the dipstick itself.
4) If the level is low, fill up slowly through oiling port (figure above). Do not overfill. After having added the
oil, wait for one minute before checking the level once again.
5) Insert and tighten the level dipstick.
The machine is equipped with
For a complete oil change (about 1.1 L), drain the oil by removing the draining bolt (see figure). Then, close
the hole and proceed to load the new oil by checking its level.
IMPORTANT: Always dispose of used oil according to the regulations in force in the territories of use. Do
not disperse into the environment.
7c – CHECKS AND MAINTENANCE OPERATIONS TO BE CARRIED OUT
1) AIR FILTER CLEANING
The air filter cleaning is essential for these machines, and it
is
an operation which must be carried out before each
With reference to the figure on the side:
- Remove the screws (
- Raise the plastic cover (
- Check and if necessary clean the filter element (
assy
)
- Reassemble the components in reverse order
2) CHECK OF ALL MANUAL CONTROL ELEMENTS, LEVERS AND
PEDALS FUNCTIONING. Visual check first, then manual check
with the machine off. Check that everything is fixed
correctly, without unusual clearance, clean, greased and
ready to be used for work operations. All control elements
SAE 30
oil from the factory.
BEFORE EACH USE
air cleaner bolt
) by hand
cover assy
)
Before topping up or checking the engine oil
level:
- Make sure that the machine is on a flat
surface.
- Remove all debris from the oil filling area.
Carry out the following operations only with
the engine off and cold, with its ignition key
removed.
Check and possible top-up:
1) Remove the level dipstick (see figure on
the side) and clean it with a cloth.
2) Insert the dipstick again.
use.
element
35451510IT - FOX MINI 85-2WD User and Maintenance Manual
Advertisement
