Advertisement
Page 4 of 36
EXPLANATION OF THE PICTOGRAMS ON THE MACHINE:
1) Engine revolutions adjustment, from minimum to maximum. While cutting, always keep it on MAX.
2) Rotor engagement (
Prohibition of cleaning the machine using a water jet
3)
Operators with a pacemaker are not allowed to come into contact with the electrical parts.
with the exception of the rotor washing, for which a special hose holder is supplied, as shown in chapter 4b
(1)
4) Burn hazard due to hot metal covers in the area around engine and muffler.
5) Ignition hazard due to flammable fuel: do not smoke! Use lead-free petrol only and do not fill
above the maximum allowed level. Fill up the tank slowly to avoid spilling the fuel.
6) Before operating the machine, read and understand this manual. Object projection hazard. Keep a
safety distance from other people, objects and animals. Maximum allowed slope during continuous
use in all directions equal to 15° (28%). Be careful not to come into contact with the rotating
mechanical parts, even if they are protected. Before any maintenance operation, remove the ignition
key and spark plug cap. Beware of the danger of inhaling harmful exhaust gases, even in open
spaces (when the operator is downwind). The use of
noise earmuffs, gloves and work shoes, is mandatory.
7) Ignition key positions and clicks: turn clockwise to turn the tractor on.
8) Before each use, check the level of the hydrostatic oil and engine oil.
CLEAN THE ENGINE CONVEYOR, CLEAN AIR FILTER BEFORE EVERY USE!
9) Meaning: "
10) It indicates the pedal to the left of the steering wheel: when pressed, the rear differential lock is
engaged.
11) Stepping on the rotor casing is forbidden, do not use it as a ladder. Do not put your hands inside
the casing.
12) Pay attention to the moving parts on the rear, especially the hydrostatic unit cooling fan.
13) Positions of the parking brake lever.
14) It indicates the pedal to the right of the steering wheel: when pressed, the machine brakes.
15) It indicates the FIXED cutting positions.
16) It indicates the FLOATING cutting positions.
17) It indicates the cutting height adjustment lever.
18) Rotor bearings greasing reminder.
19) Rotating parts hazard (belt drive under the protective casing).
PTO ON
PTO OFF
to operate,
rotor stopped).
or a high-pressure water jet cleaner.
(1)
Personal Protective Equipment
35451480EN ‐ FOX 110‐4WD and FOX 95‐4WD User and Maintenance Manual
, such as anti-
"
Advertisement
