Advertisement
Page 21 of 36
Petrol tank cap
The petrol tank is located on the left (from the operator position); the cap
(shown on the side) is unscrewed by hand, without a key. Use a funnel to make
refills easier; immediately wipe dry any spills and observe all the fuel-related
Chap. 3c
7b
instructions contained in this manual (
and
) and in the engine
manufacturer manual.
As shown in the engine manufacturer manual, the petrol must be compliant
with the following requirements:
- These engines are certified to work with clean, new, lead-free petrol.
- Minimum 87 octanes/87 AKI (91 RON).
- Petrol having an ethanol (petrol-alcohol mixture) content up to 10% is allowed.
Note: Do not use unapproved petrol types, such as E15 or E85. Do not add oil to the petrol and do not modify
the engine so it can work with alternative fuel types. The use of unapproved fuel types leads to damage not
covered by the warranty.
At altitudes above 1,500 metres, petrol with a minimum octane number of 85/85 AKI (89 RON) is allowed.
Briggs & Stratton
For information on adjustments at high altitudes, contact a
authorised retailer.
PETROL TANK REFILLING:
The tank can be accessed through the cap shown in the previous paragraphs. Use a funnel and, if possible,
a fine filter, so to prevent impurities from getting in the tank. Every time fuel is used, follow also all the
Chap. 3c
instructions contained in
.
HYDROSTATIC OIL
FOX
tractors with permanent four-wheel drive (4WD) use two
hydrostatic transmissions for movement. The machine is
equipped with transmissions, hoses and external tank (see figure
on the side) already filled with the right amount of oil. It is
advisable to check the level inside the tank anyway before each
use and, in general, to inspect the zones under the machine to
check for possible leaks.
The oil tank (see Fig. on the side) is made of orange metal sheet.
It is located behind the operator seat, on the left side from the
driving position. It has a red cap on its upper part, which must
not be confused with the yellow cap on its right (engine oil level).
The hydrostatic transmissions, hoses and oil tank are factory-equipped with:
multi-purpose hydraulic oil (UTTO) ENI MULTITECH JD/F 10W-30
The use of any other type of oil on these utilities is forbidden; otherwise, the manufacturer warranty on
Tuff-Torq
hydrostatic transmissions will become void (
).
Transmissions, system and external tank contain in total more than 6 litres of oil; however, for simple,
periodical top-ups, few decilitres are enough.
35451480EN ‐ FOX 110‐4WD and FOX 95‐4WD User and Maintenance Manual
Advertisement
