Advertisement
Page 26 of 36
- TOTAL replacement of the hydrostatic oil in the entire system and rear transmission oil filter cleaning.
=> this is a relatively complex operation, contact
Note: if the usual noise level of the transmissions increases and/or performances on slopes decrease in
quality, consider the possibility of a total oil replacement even before the 100-hour mark.
Every 150
- Replace the rotor support bearings.
Every 250
- Replace the air filter => see
Every 500
- Total replacement of the bevel gearbox oil, see explanation in the following paragraphs.
Once a year
- Replace the spark plugs => see
When needed
- Battery replacement:
► During maintenance, keep metal objects away from the poles.
► Use original batteries only. They are sealed, dry-charged and designed for use on slopes, as
they have no acid leaks.
► Follow the instructions described in the battery manufacturer's manual supplied with this machine
manual.
When the battery is disconnected (in order to install another one of the same type):
- Disconnect the negative black pole (-)
- Disconnect the positive red pole (+)
- Remove the flat battery and install the new one
- Connect the positive red pole (+)
- Connect the negative black pole (-)
Follow this operation order also when the standard battery is removed to charge it during winter storage.
To remove the battery (after disconnecting the poles as indicated), simply disassemble the sheet metal
retainer that holds it in place.
PLEASE NOTE: the manufacturer WILL NOT BE RESPONSIBLE for any damage caused by a short circuit due to
a wrong pole connection; the same applies to faults caused using non-original batteries!
To be sure that the machine promptly starts at any moment, it is also advisable to periodically check the
electrical wiring conditions, as well its connections and terminals. Clean the oxidised contacts and check that
covers and sheaths are in good conditions. To protect the electrical components, it is essential to keep the
machine away from running water, rain, and humidity.
Moreover, washing the machine with a high-pressure water jet cleaner is STRONGLY DISCOURAGED.
- Tyre or full wheel replacement:
In both cases, it is ESSENTIAL to replace them with others of the same size and type: 4WD
drives are in fact designed to work exclusively with the wheel sizes established by the
manufacturer. OTHERWISE, THE HYDROSTATIC AXLES WILL SUFFER SERIOUS INTERNAL DAMAGE!
Meccanica Benassi
Briggs & Stratton
manual.
Briggs & Stratton manual.
for support.
35451480EN ‐ FOX 110‐4WD and FOX 95‐4WD User and Maintenance Manual
Advertisement
