Advertisement
Page 16 of 36
view). In these positions, if the deck encounters a small bump, it can rise a few centimetres following the
terrain, and then returns to the selected height once it has passed the bump.
Fixed positions
(A to D) are located on the right side of the selection grid (from the operator's point of
view), and they "force" the mowing deck to maintain the selected height even in the presence of obstacles
or vegetation pushing from the bottom upwards.
Purpose:
Floating positions from 1 to 6 are used to cut a mainly grassy terrain without obstacles or trunks: this way,
the cutting result will have uniform height even in the presence of small depressions, bumps and descents.
Fixed positions from A to D are useful in case of more demanding conditions, when the raw terrain to be
shredded has resistant trunks, small trunks, shrubs to be bent with force before being shredded, etc. In
these positions, the mowing deck remains in its position, and it is not "pushed back" by the obstacles,
allowing to shred them in the best way.
ALL TRANSFERS MUST BE MADE WITH THE LEVER IN POSITION 6 AND WITH THE TOOLS NOT
INSERTED
11 – Rear transmission by-pass lever
This lever has two positions:
- Lever [#11] all forward, "ON" in the previous figure: DRIVE is ENGAGED, the machine can operate
- Lever [#11] all backward (coming off the rear part), "OFF" in the previous figure: the rear transmission is
free, and the machine can be moved with its engine off. Note: never use the OFF position while the machine
is on a slope!
IMPORTANT: BRING always the lever BACK to ON position before starting a new work: otherwise, the machine
will not move, and the hydrostatic transmission might get damaged!
BEWARE in case the machine is moved by pushing it: do not touch the rear grid while the
Finally,
machine is still hot, burn hazard!
12 - Choke
For cold starts, control #12 must be pulled upward to close the air: when the engine is warm, bring the
control back down to restore proper operation before starting work.
ON
◄
OFF
◄
35451480EN ‐ FOX 110‐4WD and FOX 95‐4WD User and Maintenance Manual
Lever [#11] has the purpose of bypassing
the rear transmission, so to allow machine
movements with the engine off. In 4WD
tractors, this option can be used only
partially: the front hydrostatic transmission
will
in
any
case
exercise
resistance, as it does not have its own by-
pass. Therefore, proceed slowly.
a
certain
Advertisement
