Hydrostatic Oil - Meccanica Benassi FOX 95-2WD User And Maintenance Manual

Page 21 of 36
Petrol tank cap
The petrol tank is located on the left (from the operator position); the cap
(shown on the side) is unscrewed by hand, without a key. Use a funnel to make
refills easier; immediately wipe dry any spills and observe all the fuel-related
instructions contained in this manual (
manufacturer manual.
As shown in the engine manufacturer manual, the petrol must be compliant
with the following requirements:
- These engines are certified to work with clean, new, lead-free petrol.
- Minimum 87 octanes/87 AKI (91 RON).
- Petrol having an ethanol (petrol-alcohol mixture) content up to 10% is allowed.
Note: Do not use unapproved petrol types, such as E15 or E85. Do not add oil to the petrol and do not modify
the engine so it can work with alternative fuel types. The use of unapproved fuel types leads to damage not
covered by the warranty.
At altitudes above 1,500 metres, petrol with a minimum octane number of 85/85 AKI (89 RON) is allowed.
For information on adjustments at high altitudes, contact a
PETROL TANK REFILLING:
The tank can be accessed through the cap shown in the previous paragraphs. Use a funnel and, if possible,
a fine filter, so to prevent impurities from getting in the tank. Every time fuel is used, follow also all the
instructions contained in

HYDROSTATIC OIL

FOX 2WD
The tractor relies on a hydrostatic transmission
for movement. The
transmission, hose and external tank (see figure on the
side) already filled with the right amount of oil. It is
advisable to check the level inside the tank anyway before
each use and, in general, to inspect the zones under the
machine to check for possible leaks.
The oil tank (see Fig. on the side) is located behind the
operator seat, on the left side from the driving position.
It's sealed by a black plastic cap that can be unscrewed
by hand.
The hydrostatic transmission, hose and oil tank are factory-equipped with:
multi-purpose hydraulic oil (UTTO) ENI MULTITECH JD/F 10W-30
The use of any other type of oil on these utilities is forbidden; otherwise, the manufacturer's warranty on the
hydrostatic transmission will become void (
The transmission, hose and external tank contain in total more than 2 litres of oil; however, for simple and
periodical top-ups, a few decilitres are enough.
HYDROSTATIC OIL LEVEL CHECK: with the machine in horizontal position and cold oil (i.e. BEFORE a work
session) check that the level is around the mark engraved in the tank.
PLEASE NOTE: always leave some room to allow the hot oil to expand. Never fill the tank completely.
Chap. 3c
Chap. 3c
.
machine is equipped
Tuff-Torq
7b
and ) and in the engine
Briggs & Stratton
with
).
35451490EN - FOX 95-2WD User and Maintenance Manual
authorised retailer.