Table of Contents
Advertisement
Computing On the Road
CAUTION
When installed in a network environment.
Do not use the standby or hibernation function.
After resuming operation from the standby or hibernation mode, the network con-
nection may be severed or the computer will not work properly.
When a device like a high-speed modem or ISDN terminal adaptor is connected
to the serial port, etc.
There are times when high-speed communication is adversely affected if the power
management function is enabled.
Key operation and music playback.
When the power management function is running, you may feel that key or touch
pad (or mouse) operations are sluggish. Furthermore, music may not be played
back correctly when the power of the display is cut (for energy conservation pur-
poses) during playback.
Setting the Power Management
1
Run the Setup Utility
2
Using
and
3
Using
and
Enter
4
Using
and
, select either [Enable (Battery)] or [Enable (Always)]
and press Enter
5
Press F10 and select [Yes], then press Enter
Power Management Mode settings
Power Management
Functions
Mode
automatically set
HDD Motor Timeout
ECO Mode Timeout
Power Conservation
(AC Adaptor Connected)
* Enabled only when the battery itself is being used.
HDD Motor Timeout/ECO Mode Timeout
If there is no input from a key, the touch pad, or a mouse for more than two minutes,
the power to the LCD is cut and the hard disk motor is turned off. Even when an
application software is being installed or a disc is being accessed, the computer
may enter the ECO mode (except when the [Power Management Mode] is set to
[Disable]).
Windows NT
(
page
54)
, select [Power]
, select [Power Management Mode] and press
Windows NT
Enable (Always) Enable (Battery)* Disable
(Setting at the time of
purchase)
2 min
2 min
2 min
2 min
Enable
Disable
23
Never
Never
Disable
Advertisement
Table of Contents
