Table of Contents
Advertisement
Standby/Hibernation Functions
Shutting Down Using the Standby or Hibernation Function
The computer should be set for standby or hibernation (
Slide the power switch; at the "beep*
(After releasing your finger from the
power switch, do not touch the power
switch until the power indicator goes off
or blinks.)
CAUTION
At the "beep*
1
" sound, release your finger from the power switch. If you con-
tinue to slide the switch and hold it for more than four seconds, the "beep*
sound will come out again and the power will go off. Data not previously saved
will be lost.
Windows 98
Windows 2000
Even when [When I press the power button on my computer] is set to [Shut-
down]*
2
with [Control Panel] - [Power Management]*
switch for more than four seconds and do not release it, a beep will sound and
the power will go off, although the computer will not completely shut down.
*
Windows 2000 : [Power Off]
2
*
3
Windows 2000 : [Power Options]
Windows NT
When [Power Switch] is set to [Off] in the Setup Utility, if you slide the power
switch, the computer will turn off and all unsaved data will be lost.
*
When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
1
Setup Utility (
page
sound.
NOTE
With the method below, you can shut down the computer by using the standby
function.
• Fn + F7 (
•
Windows 98
Windows 2000
In [Start] - [Shut Down], select [Stand by].
•
Windows NT
In [Control Panel] - [APM 2.0 for NT] - [Power Control], select [Click Here to
Suspend]. (
With the method below, you can shut down the computer by using the hiber-
nation function.
• Fn + F10 (
Windows 2000
•
In [Start] - [Shut Down], select [Hibernate].
" sound, release your finger.
1
55) or by the key combination
page
3)
page
24)
page
3)
page
12).
Standby Mode
or
Hibernation Mode
3
, if you slide the power
, there will be no beep
Fn + F4
13
1
"
Advertisement
Table of Contents
