Panasonic CF72/q Reference Manual page 14

Standby/Hibernation Functions
Resuming Operation
Slide the power switch
• Windows NT
If the security indicator (
This password has been set in the Setup Utility and is not a Windows NT pass-
word.
Windows 98 Windows 2000
•
When the computer enters the standby or hibernation mode by the closing of the
LCD panel, it will resume when the LCD panel is opened. If the computer does
not resume when the LCD panel is opened, slide the power switch.
CAUTION
After the display returns, the computer needs a short period of time to reinitialize.
This takes about 30 seconds. Do not shut down or restart Windows, or use
the standby or hibernation functions again during this time, as this may sub-
sequently cause Windows to operate abnormally.
Do not install or remove peripherals while your computer is in the standby or
hibernation mode; abnormal operation may result.
When operation resumes, serial devices such as a mouse, modem or PC
Cards may not function properly. In such cases, you will need to restart your
computer or reinitialize the individual devices.
Avoid the following until the power is completely turned off when turning off
the computer by using the standby or hibernation functions, or resuming op-
eration from the standby or hibernation.
• Touch the keyboard (excluding password input), touch pad or power switch.
• Connect the AC adaptor.
• Close the display.
Windows 98 Windows 2000
Even when a password has been set in the Setup Utility,
when the computer resumes from the standby or hibernation mode.
(If you want to use the security function when using the standby or hiberna-
tion mode, add the check mark for [Prompt for password when computer
goes off standby.] in [Control Panel] - [Power Management]* - [Advanced].)
* Windows 2000 : [Power Options]
) is displayed, your password has been set.
14
does not appear