Table of Contents
Advertisement
Security Measures
Setting the Supervisor Password
NOTE
When the User Password is set, the Supervisor Password will be needed.
1
Run the Setup Utility
2
Using
and
3
Using
and
press Enter
4
<Only when the Supervisor Password has been set>
Enter your password at the [Enter Current Password], then
press
Enter
5
Enter your password at the [Enter New Password], then
press
Enter
To disable the Supervisor Password
Press only Enter
NOTE
Your password will not be displayed on the screen.
Limit your password to seven characters. Note that there is no distinction
between upper and lower case letters.
White colored keys can be used. Note that the space bar and function
keys cannot be used.
6
Re-enter your password at the [Confirm New Password] , then
press
Enter
To disable the Supervisor Password
Press only Enter
7
At the [Setup Notice], press Enter
8
Press F10 and then select [Yes], then press Enter
CAUTION
Do not input your password while holding down on Shift or
Use only the upper horizontal row of numeric keys to input your password.
Do not forget your password. If your Supervisor Password is forgotten you will
be unable to use your computer. Contact Panasonic Technical Support.
When running the Setup Utility, do not leave your computer even for a short
time, as the possibility exists for the password to be set/changed by another
person.
(enabling, changing, disabling)
(
page
54)
, select [Security]
, select [Set Supervisor Password], then
18
Ctrl .
Advertisement
Table of Contents
