Troubleshooting - ECG ERB 21530 WE Instruction Manual

Replacement of the bulb in the refrigerator
For models that have a bulb*
1. Unplug the appliance from the power supply.
2. Press the hooks on the sides of the top of the cover and remove the bulb cover.
3. Replace the defective bulb with a new one with maximum power 15 W.
4. Install the bulb cover and connect the appliance to the power supply after 5 minutes.
For models with LED lighting*
Do not replace the LED lighting yourself. Contact the service representatives.
* differs according to the specific model of the appliance – see information sheet
Reversing the door opening
If you need to change the direction of opening the door, consult your service technician.

TROUBLESHOOTING

If the refrigerator does not work correctly, before calling a service technician, check the appliance according
to the following instructions:
The refrigerator does not work
Check that:
• The electricity supply is not interrupted.
• The main switch for the electric current is not off.
the thermostat is not set to 0 position,
•
• The electricity socket is working. To check, plug another appliance that you know is working into the same
socket.
The performance of the refrigerator is low
Check that:
• there is not too much food placed in the appliance,
• is the thermostat set to position 1 (if yes, set the thermostat to a higher value)
• is the door properly closed,
• isn't there dust on the condenser,
• is there is enough space around the rear and side walls to circulate the air.
The refrigerator is noisy
Cooling gas, which circulates in the refrigerator, may cause a slight noise (bubbling sound) even when the
compressor is not running. Do not worry, this is completely normal. If these sounds are different, make sure
that:
• the appliance is in the horizontal position,
• It is not in contact with the rear side.
• Parts of the appliance do not vibrate.
14