Cleaning And Maintenance; Troubleshooting - ECG ERT 10860 WE Instruction Manual

Hide thumbs Also See for ERT 10860 WE:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Door open indicator - depends on the model.
The "door open » indicator on the handle shows whether the door is open or has been
properly closed.
If the indicator is red, the door is still open.
When the indicator is white, the door is properly closed.
Pay attention to the door so that it is always carefully closed. This prevents defrosting
of food and freezing of the walls of the appliance; increased power consumption is also
a matter of course.

CLEANING AND MAINTENANCE

Before you start cleaning the refrigerator, remove the power cord plug from the outlet.
Carefully wipe the refrigerator with a cloth soaked in a mild detergent solution. Do not use abrasive
cleaners, alkaline cleaners and alkalis, chemical wipes, thinner, alcohol, acids, gasoline cleaners, or hot
water. You could damage the surface finish and plastics.
The door seal is easily clogged, clean it regularly.
If the refrigerator is not used for long periods, unplug the power cord from the outlet, dry the freezer
compartment and carefully close the door.
Clean the condenser at the rear of the appliance at least once a year. You will increase efficiency and reduce
power consumption.
Defrosting
When defrosting, remove all the food from the refrigerator and set the thermostat dial to "OFF".
Place a drip tray under the evaporator, which will collect the melted water.
After the ice melts, pour away the melted water and wipe the interior of the refrigerator dry.
You can switch the refrigerator on again by setting the thermostat to the desired temperature.
Replacement of the bulb in the refrigerator
For models that have a bulb*
1.
Unplug the appliance from the power supply.
2.
Press the hooks on the sides of the top of the cover and remove the bulb cover.
3.
Replace the defective bulb with a new one with maximum power 15 W.
4.
Install the bulb cover and connect the appliance to the power supply after 5 minutes.
For models with LED lighting*
Do not replace the LED lighting yourself. Contact the service representatives.
* differs according to the specific model of the appliance – see information sheet

TROUBLESHOOTING

You can solve a number of common problems on your own. If the refrigerator is not working properly, check
the following points before calling a service technician:
Cause
The refrigerator is not cooling. •
Check
Is the refrigerator turned on?
Is the power supply all right?
Did the fuses of the outlet on a circuit in which the refrigerator is
plugged fail?
Is the power cord plug correctly inserted in the outlet?
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Erm 10470 wfErt 10841 wfErt 10850 wfErt 10853 wf

Table of Contents