Table of Contents
Advertisement
Available languages
Available languages
5 Installing the air duct
EN
20
Fig. 5:
Insert front screws
Fig. 6:
Insert rear screws
To mount the rear angle bracket, select the corresponding hole pattern de-
pending on the IT enclosure variant (fig. 7).
Fig. 7:
Select the hole pattern
Mount the rear angle bracket on the lower cross strut at the rear of the IT rack
(fig. 8).
The bracket is mounted centrally on the cross strut with four self-tapping
M5x12 screws (M5x12 self-tapping screw NZ/TX30) and a tightening torque of
5 Nm.
TS
VX
Rittal air duct Blue e+
Advertisement
Chapters
Table of Contents
