Kia Sportage Hybrid 2024 Owner's Manual page 131

Features of your vehicle
2. On your garage door opener in your
garage, locate the "Learn" button
(usually near where the hanging
antenna wire is attached to the
garage door opener). If there is diffi -
culty locating this button, refer to the
device's owner's manual.
3. Press and release the "Learn" button.
4. A light on your garage door opener
may flash, and your Two-Way Com -
munication indicators (4), (6) in your
vehicle may flash, confirming comple -
tion of the process.
5. Return to the vehicle and firmly press
and release the programmed Home -
Link button to activate your garage
door. The Two-Way Communication
indicators (4), (6) flash in orange
when the door is moving. Do not
make any additional button presses
until AFTER the garage door has
come to a complete stop.
6. Your Two-Way Communication pro -
gramming is now complete.
NOTICE
If your garage door opener has Two-
Way Communication functionality, it is
possible for HomeLink to stop function -
ing the garage door shortly after initial
programming, if the Two-Way Commu -
nication Programming wasn't properly
completed. This usually happens after
the first 10 times a programmed Home -
Link button is pressed. If you experience
this, completing the "Programming a
New HomeLink Button" and "Two-Way
Communication Programming" will
restore door operation.
4) Canadian Programming
Canadian radio-frequency laws require
transmitter remote signals to "time-out"
(or quit) after a couple seconds of trans -
mission, which may not be long enough
for HomeLink to pick up the signal dur -
ing programming.
If you live in Canada or you are having
difficulties programming a gate operator
or garage door opener by using the pro -
gramming procedures, replace "Pro -
gramming a New HomeLink Button"
step 3 with the following:
Whilst the HomeLink indicator light (7) is
flashing orange, press and release
("cycle") your device's hand-held remote
every two seconds until the HomeLink
indicator light (7) changes from orange
to green. You may now release the
hand-held remote button. Then proceed
with "Programming a New HomeLink
Button" step 4.
2. Operating HomeLink씾
1) Operating HomeLink씾
1. Press and release the desired pro -
grammed HomeLink button (1, 2 or 3).
OCV041604N
NOTICE
The HomeLink indicator (7) should light
green, solid or flashing, and your pro -
grammed device should operate.
If your device does not operate, the
HomeLink programming was not suc -
cessful, and you'll need to reprogram the
button.
Mirrors
5
5 43