Installation; Appropriate Installation Location; Adjusting The Feet - Beko B5XRCNA366HXB User Manual

4

Installation

A
Read the "Safety Instructions" section first!

4.1. Appropriate Installation Location

Contact an Authorized Service for the
installation of the product. In order to prepare
the product for use, refer the information in
the user manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified electrician
and technician to have any necessary
arrangements carried out.
WARNING: Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
WARNING: Product must not be
plugged in during installation.
Otherwise, there is the risk of death
or serious injury!
WARNING: If the door clearance of
the room where the product shall be
place is so tight to prevent passing of
the product, remove the door of the
room and pass the product through
the door by turning it to its side; if
this does not work, contact the
authorized service.
• Place the product on an even floor surface
to prevent jolts.
• Install the product at least 30 cm away
from heat sources such as hobs, heater
cores and stoves and at least 5 cm away
from electrical ovens.
• Product must not be subjected to direct
sun light and kept in humid places.
• Appropriate air ventilation must be
provided around your product in order to
achieve an efficient operation. If the
product is to be placed in a recess in the
wall, pay attention to leave at least 5 cm
distance with the ceiling and side walls.
• Please provide at least 5cm distance for air
circulation between the back side of your
product and the wall to avoid condensation
on the rear panel of product.
• Your product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls.
• If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls. Check if the rear
wall clearance protection component is
present at its location (if provided with the
product). If the component is not available,
or if it is lost or fallen, position the product
so that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance at
the rear is important for efficient operation
of the product.

4.2. Adjusting the Feet

If the product stands unbalanced after
installation, adjust the feet on the front by
rotating them to the right or left.
4.3. Elektrische aansluiting
WARNING: Do not make
connections via extension cables
or multi-plugs.
WARNING: Damaged power cable
must be replaced by the
Authorized Service Agent.
10 / 20 EN
Refrigerator / User manual