Advertisement
WRAPAROUND FRONT STRAIGHT (Stainless Steel)
More Aggressive vs. Less Aggressive:
The more aggressive the setting of the Flex Wrap, the quicker the wrap will close and wrap around the rear of
vehicles. A unit that is set up less aggressive will not clean the backs of vehicles as good at a higher line speed.
However, the more aggressive setting can cause the brushes to climb vehicles and cause damage. It is important
to set the aggressiveness based on the line speed of the conveyor. It should take 6 to 7 seconds for the arms to
move from the retracted position to the centerline position. Initially, a little less aggressive is better than too
aggressive. During initial startup and break-in, you may be tempted to increase the aggressiveness of the
machine. The new cloth is relatively stiff during this time. However, as the cloth breaks in, cleaning performance
will increase. Foam brushes do not require a long break-in time. Injecting soap into the water supply line will
quiet the cloth, improve performance decrease break-in time, and reduce damage claims.
1. Loosen the pillow block bearings and adjust the bearing setting bolts to decrease the amount of
aggressiveness in the Flex Wrap. The brushes should be set so they just fall towards the centerline.
Once the pillow blocks have been set, tighten the attachment bolts to fully secure the bearings.
PECO Corporation – 244 Rex Boulevard – Auburn Hills – Michigan – 48326 – USA – 1-248-299-5800
07/14/23
S:\Engineering Doc's\Manuals & Packing Lists Combined\WRAP WASHERS\997206 WA721FSs_V2.doc
Operation Adjustments
OFFSET FROM NEUTRAL
LESS AGGRESSIVE SETTING
BEARING SETTING BOLTS
NEUTRAL SETTING
OFFSET FROM NEUTRAL
MORE AGGRESSIVE SETTING
www.PECOCARWASH.com
OFFSET FROM NEUTRAL
FACTORY SETTING
OFFSET FROM NEUTRAL
990372AY67
Page 20 of 33
Advertisement
