Advertisement
WRAPAROUND FRONT STRAIGHT (Stainless Steel)
1. Same as step 1 above.
2. 48 Slot Lower Cores are 12" diameter x 24" high – Load as shown below:
(Note: Slots not numbered are not used)
3. Slide the molded inserts into the slots until they stop at the bottom edge of the core.
Place these in slots 3, 5, 7, 12, 14, 16, 21, 23, 25, 30, 32, and 34. Repeat for each
lower core.
4. Slide 81/4" high x 18" long 1 Ply cloth panels into the slots until they stop at the bottom
edge of the core. Place these in slots 1, 2, 4, 6, 8, 9, 10, 11, 13, 15, 17, 18, 19, 20, 22,
24, 26, 27, 28, 29, 31, 33, 35, and 36. Repeat for each lower core.
PECO Corporation – 244 Rex Boulevard – Auburn Hills – Michigan – 48326 – USA – 1-248-299-5800
07/14/23
S:\Engineering Doc's\Manuals & Packing Lists Combined\WRAP WASHERS\997206 WA721FSs_V2.doc
www.PECOCARWASH.com
Page 13 of 33
Advertisement
