FLIR Ex Series Getting Started page 9

2 EN-US English
2.10 Keypad
See Figure 1.2 Keypad, page 1.
1. Camera screen.
2. Archive button
• Push to open the image archive.
3. Navigation pad.
• Push left/right or up/down to navigate in menus, submenus, and dialog
boxes.
• Push the center to confirm.
4. Cancel button
• Push to cancel a choice.
• Push to go back into the menu system.
5. On/off button
• Push the
• Push and hold the
in standby mode. The camera then automatically turns off after 48 hours.
• Push and hold the
camera.
2.11 Connectors
See Figure 1.3 Connectors, page 2.
The purpose of this USB mini-B connector is the following:
• Charging the battery using the FLIR power supply.
• Charging the battery using a USB cable connected to a computer.
Note Charging the camera using a USB cable connected to a computer
takes considerably longer than using the FLIR power supply or the FLIR
stand-alone battery charger.
• Moving images from the camera to a computer for further analysis in FLIR
Thermography software.
#T810136; r. AB/79818/79818; mul
.
.
button to turn on the camera.
button for less than 5 seconds to put the camera
button for more than 10 seconds to turn off the
6