Husqvarna TC 112 Operator's Manual page 36

Problem
The engine has no power.
The engine stops when you try to op-
erate the product rearward.
The transmission does not have suffi-
cient power.
The battery does not charge.
There is vibration in the product.
36
Cause
The air filter is clogged.
The spark plug is damaged.
There is dirt in the carburetor or fuel
line.
The throttle cable is incorrectly adjus-
ted.
The reverse operation system (ROS)
is not engaged.
The transmission air intake or the
cooling fins are blocked.
The fan on the transmission is dam-
aged.
There is no oil in the transmission or
the oil level is too low.
The drive system is disengaged.
The battery is damaged.
The connection at the battery termi-
nals is bad.
The blades are loose.
The blades are incorrectly installed.
The blades are not balanced.
The engine is loose.
The belt pulleys are skew or loose.
Action
Clean or replace the air filter. Refer
To clean and replace the air filter
to
on page 26 .
Examine the spark plugs. Replace
the spark plugs if it is necessary.
To examine and replace a
Refer to
spark plug on page 26 .
Speak to your Husqvarna servicing
dealer.
Speak to your Husqvarna servicing
dealer.
Engage the reverse operation system
To use the reverse
(ROS). Refer to
operation system (ROS) on page 20 .
Speak to your Husqvarna servicing
dealer.
Speak to your Husqvarna servicing
dealer.
Speak to your Husqvarna servicing
dealer.
Engage the drive system. Refer to
engage and disengage the drive sys-
tem on page 18 .
Replace the battery. Refer to
place the battery on page 28 .
Make sure that the battery is connec-
To connect the
ted correctly. Refer to
battery on page 16 .
Tighten the blades. Refer to
cal data on page 40 .
Make sure that the blades are instal-
led correctly. Refer to To examine
the blades on page 31 .
Examine the blades for wear and
damage. Refer to To examine the
blades on page 31 .
Speak to your Husqvarna servicing
dealer.
Speak to your Husqvarna servicing
dealer.
1903 - 004 - 18.12.2023
To
To re-
Techni-